COF – Adjustable Chain Oil Feeder

A chain oiler applied to your drive chain, can greatly improve a drives performance operating life efficiently. The oil penetrates into the pin and bushing surface and maintain the oil film in this area, which will greatly reduce the wear and will prevent chain failure by providing protection against rust and corrosion. COF feeders can automatically function as pre-determined rates to prevent over and under lubrication in which will increase both chain life and efficiently.

Item No.COF-85COF-165
Material Aluminum AlloyAluminum Alloy
Dimension120 x Φ55 mm134.5 x Φ68 mm
Brush Dimension1-1/2″ x 1/2″
(38 mm x 15 mm)
1-1/2″ x 1/2″
(38 mm x 15 mm)
Cup Volume85 C.C.165 C.C.
Oil RequiredSAE50 Chain OilSAE50 Chain Oil
Packing12 pcs/case12 pcs/case

AOF – Adjustable Oil Feeder

Drip flowing feeder oilers are the popular method of automatic oil lubrication. The oil feeding rate ca be set by turning the needel valve and also can be installed by three different kinds of adapters to the oil flowing end to meet the oil output volume requirement. Since this oiler can be applied to various kinds of machinery. To lubricate such as : chain, gear, cam, roller, bearing, sliding surface, screw and shaft, …etc.

Item No.AOF-85AOF-165
Material Aluminum AlloyAluminum Alloy
Dimension120 x Φ85 mm134.5 x Φ68 mm
Cup Volume85 C.C.165 C.C.
Oil RequiredSAE 10~140SAE 10~140
Packing12 pcs/case12 pcs/case

BGF- Single Point Grease Feeder

Single point bearing greaser feeders operate without any power requirement. Using double springs provides 3 psi pressure to fill the grease into bearings form time to time continuously while machinery in operation. Aluminum alloy feeder base will not rust; transparent cup easy to check the greaser volume. Adjustable valve can be controlled the grease filling volume. It is suitable to install indoor and out door at temperature -4°F~260°F.

Installation :
1. Be sure eliminate the original greaser from bearings before install the feeders to the
machinery. If the original grease cannot be pressed out, it means that the original grease
may be harden, please replace the bearing.
2. Suitable for using NLGI-0~2.0 grease and be sure without any foreign object.
3. Make sure no residual air leaving in the grease feeding system. The remaining air will
cause the grease flow unevenly.
4. Use grease gun to fill the grease into the feeder until the grease fill out from the seal of
the bearing.

Specification
Item No.BGF-58BGF-125
MaterialAluminum AlloyAluminum alloy
Diemnsion120 x Φ55 mm134.5 x Φ68 mm
Grease Volume58g125g
Output Pressure3 psi3 psi
Packing12 pcs/case12 pcs/case
adapter speciation
Adapter No.V1V2V3
Size1/4″ PT191/8″ PT281/16″ UNF28
Angle180°180°180°
flowing reference chart
Grease NLGI012
Grease Output Volume0.15g/hr0.10g/hr0.05g/hr
Base on V2 Full Open

Cordless Type (Electric Powered) EGN-1600

Due to the special function of the portable, quick continuous flowing, cordless electrical powered grease gun make this “LUBEGUARD” #EGN-1600 very popular to be used in the emergency applications of the maintenance work outdoor. For such as military weapon & equipment, automobile, marine, crane, construction equipment, and the general industrial of machinery…etc.

Operating Power12 Volt 1.5AhOutput pressure6,000 psi
Operating Noise<80dbGrease GradeNLGI 0~2
Output Volume170g/minTime to dispense
one grease
2.5 minutes
A single battery
dispensability
8 ~ 11 tubesNet Weight3.2 kg/set
3 ways for loadinga.14 oz cartridgeb.500 g bulkc.Filler pump

#AS-6001 NiCd Rechargeable Battery : 12Volt, 1.5Ah. Weight : 650g/Pc
#AS-6002 Charger : Two types
1. Input : AC120V 60Hz Output : DC12V 1.5A Weight : 1Kg/Pc
2. Input : AC230V 50Hz Output : DC12V 1.5A Weight : 1Kg/Pc

One full set including :
1 Pc Grease Gun
1 Pc Battery
1 Pc Charger
1 Pc Shoulder Strap
1 Pc Carrying case




LGA – Grease Gun – Air Powered

  • 40:1 ratio air motor
  • Heavy duty cast aluminum body for maximum durability and longer service life
  • 3-way loading-Bulk, filler pump or 14 oz grease cartridge
  • Bleeder Valve for purging unwanted air
  • Durable follower rod & spring for consistent priming
  • Postitive grip follower handle
  • 4-Jaw super grip coupler for better grip and longer service life
  • Non-Slip knurled better grip
  • 6″ curved pipe with standard coupler
  • 1 ~ 1.3g per stroke.
TypeSingle Shot Grease Gun KitContinuous Shot
ModelLGA-1400LGA-1400KLGA-2400
Input Pressure40-100 psi40-100 psi40-100 psi
Output Pressure1,600 ~
4,000 psi
1,600 ~
4,000 psi
1,600 ~
4,000 psi
Per Stroke1~1.3g1~1.3g288g/min
Capacity 14oz cartridge
450g bulk
14oz cartridge
450g bulk
14oz cartridge
450g bulk
Weight
KGS/Pc
1.61.81.6
Packing
Pcs/Carton
101010

LGA-1400

LGA-1400K

LGA-2400

LGN- Grease Gun – Hand Operated

  • Aluminum Alloy grease gun head
  • Chrome plated finish for long service life
  • Short stroke “lever action” for easy use
  • Positive lock for easy filling
  • Knurled thick wall barrel for secure grip
  • Come with 6″ curved pipe with standard coupler
  • 0.7g per stroke
TypeLever ActionHeavy DutyExtreme Heavy Duty
Model LGN-1460LGN-1470LGN-1490
Outlet
Pressure
4,300 psi6,000 psi8,000~10,000 psi
Capacity14 oz cartridge
500 g bulk
14 oz cartridge
500 g bulk
14 oz cartridge
500 g bulk
Weight
KGS/Pc
1.31.41.57
Packing
Pcs/Carton
151510

LGN-1460

LGN-1470

LGN-1490

LUBEGUARD – Lubricating Equipment

Grease Gun

Hand Operated – Lever Action

Pistol Type

Pneumatic Type (Air Powdered)

Jiabara Type

Mini Type

Cordless Type (Electric Powered)

Grease Gun Accessories

Single Point Bearing Grease Feeder & Automatic Oil Feeders


CCG-201/CCG-203 連續式 電動式 矽膠灌注鎗

種類電動 連續式
-管狀
電動 連續式
-臘腸狀
編號CCG-201CCG-203
電壓7.2V
鋰離子電池
7.2V
鋰離子電池
最大推力450kgf ±45450kgf ±45
空載速度5.5mm/秒5.5mm/秒
總長390mm380mm
支架尺寸
適用型式
9寸
(310ml硬管)
9寸
(310ml硬管)/
400ml臘腸狀
使用量
單顆電池
80~100條Min :100條
淨重1.25公斤1.3公斤
尺寸(mm)
長x寬x高
390x70x225390x70x225
配件1支矽利康鎗
1只鋰電池
1只充電器
1只手提箱
1支矽利康鎗
1只鋰電池
1只充電器
1只手提箱

CCG-201 連續式 電動式 矽膠灌注鎗
電壓 : 7.4V 1.3安培 (鋰電池,可充電式)
最大輸出壓力 : 240 公斤力 (Kgf)
速度 (無裝載) : 5.8 mm/秒
最大伸展長度 : 212 mm
矽膠筒裝尺寸 : 9″ (310ml)
可使用矽利康膠數量 : 80~100條 /單顆充飽電池
淨重 : 1.3 公斤/支
尺寸 : 390mm (長) x 70mm(寬) x 225mm (高)

CCG-203 連續式 電動式 矽膠灌注鎗
電壓 : 7.4V 1.3安培 (鋰電池,可充電式)
最大輸出壓力 : 240 公斤力 (Kgf)
速度 (無裝載) : 5.8 mm/秒
最大伸展長度 : 194 mm
矽膠筒裝尺寸 : 9″ (筒裝 310ml / 臘腸包裝 400ml)
可使用矽利康膠數量 : 80~100條 /單顆充飽電池
淨重 : 1.35 公斤/支
尺寸 : 380mm (長) x 70mm(寬) x 225mm (高)